GB/T 1219

Active

Dial gauges

指示表

Standard Type

GBT

ICS

17.040.30

CCS

J42

Status

现行

Issue Date

2008-02-02

Implementation

2008-07-01

Responsible Dept

中国机械工业联合会

Drafting Unit

中国机械工业联合会

📋 Scope / 适用范围 ai_extracted

本标准规定了测厚规的型式基本参数与尺寸技术要求标志与包装等本标准适用于分度值为0.01mm 测量范围0~10mm 的测厚规

📝 Foreword / 前言 ai_extracted

本标准是在ZB J42 014—87 测厚规的基础上修订的本标准与ZB J42 014—87 的技术内容一致仅按有关规定重新进行了编辑本标准自实施之日起代替ZB J42 014—87 本标准的附录A 是标准的附录本标准由全国量具量仪标准化技术委员会提出并归口本标准负责起草单位桂林量具刃具厂本标准参加起草单位威海量具厂本标准主要起草人林观华杨盛文本标准于1987 年首次发布 JB/T 10016 1999

📚 References & Relations / 引用与关联

normative_reference GB/T 1219-1985

normative_reference GB/T 17163-1997

normative_reference GB/T 17164-1997

🔗 Related Standards / 同类标准

GB/Z 26958.22-2011 Geometrical Product Specifications (GPS) - Filtration - Part 22: Linear profile filters : Spline filters GB/Z 26958.20-2011 Geometrical Product Specifications (GPS) - Filtration - Part 20: Linear profile filters: Basic concepts GB/Z 26958.30-2017 Geometrical product specifications (GPS)—Filtration—Part 30: Robust profile filters—Basic concept GB/T 5371-1985 Tolerances and fits--The calculation and selection of interference fits GB/T 7234-1987 Measurement of roundness--Terms, definitions and parameters of roundness GB/T 11334-1989 Cone tolerance GB/T 12360-1990 Cone fit GB/T 3374-1992 Basic terminology of gears

Content extracted by AI. Not officially verified.